Any thoughts on what might be going on and how I might troubleshoot further? Thanks in advance. When I've used it on a mac, it works perfectly. I rarely use the UMC device, and have only plugged it in a few times over the past few days repeating the steps I described above. Setup for mic: Mic-XLR to Input 1/2, Pad pressed/depressed, Phantom power on, Gain between 50-100%ĭrivers have been installed from Behringer's website. Behringer UMC404HD Specifications: Type Operating systems Drivers USB 2.0, type B Mac OS X, Windows XP or higher Mac: No driver required / CoreAudio. Setup for instrument: Bass-1/4" cable to Input 1/2, INST pressed in, tried both pressed in/out for Pad, Gain between 50-100% (I've tried using my guitars, as well as multiple cables too) I can confirm that the PC sees the device(s). I was wondering if signal was still passing, and attempted to record in my DAW (Studio One), but no signal was recorded. I also have a Behringer UMC404HD, and that is producing the same results. I also connected the hardware to a powered USB port, but still no luck. You can also try running the UMC404HD through a USB 3.0 hub into your USB 3.0 port on your computer to see if that works any better for you. So, it would be recommended to only use the unit with USB 2.0 ports on your computer. I've also tried plugging into channel 2 with the same result hooking up a condenser mic on both channels with no apparent signal either. The USB port on the UMC404HD is a USB 2.0 port. However, I'm not getting any indication of input signal on the UMC device (no green light on 'SIG').
I'm attempting to use a bass plugged directly through my Behringer UMC204HD into my laptop (W10 PC).
0 kommentar(er)
